From the Turn off the display drop-down list, select Never for Plugged in. From the Turn off the display drop-down list, select 1 hour for On battery. In the Plan name field, enter Presentation. Under Related settings, select Additional power settings. From the left menu, select Power & sleep. The Status window shows an active connection to the network and the internet.Ĭreate a custom power plan as follows: Select Start. After the operating system loads, right-click the Network icon and select Open Network & Internet settings. Click the power button on the computer case to turn the computer on. Confirm that the computer is connected to the local network and the internet as follows: Above the computer, select Front to switch to the front view of the computer. In the Selected Component window, drag the other connector to the Ethernet port on the wall outlet. In the Selected Component window, drag a connector to the NIC port on the 1000BaseTX network adapter. PCIe Slot Connect the computer to the network as follows: Above the computer, select Back to switch to the back view of the computer. Drag the 1000BaseTX network adapter to a free PCIe slot on the computer. When the BIOS loading window appears, press F2 to enter the BIOS.Īctions you were required to perform: Install the 1000BaseTX network adapter in the Support workstation Connect the new NIC to the network using a Cat6a cable Verify that the Support workstation can communicate with the internet using the new NIC Above the computer, select Motherboard to switch to the motherboard view of the computer. On the computer, select the power button on the front of the computer. Boot into the BIOS and verify that all installed modules are recognized by the BIOS as follows: Above the computer, select Front to switch to the front view of the computer. Repeat steps 2b-2c until all memory slots in the computer are filled with good modules. If the memory tester indicates OK, the module is good drag the module to the computer. If the memory tester indicates BAD or ERROR, the module is bad return the module to the Shelf. Drag a memory module from the Shelf to the correct slot on the memory tester. Test and install the memory modules on the Shelf as follows: On the Shelf, expand Memory Modules. Repeat steps 1d-1e for all memory modules in the computer. If the memory tester indicates OK, the module is good. If the memory tester indicates BAD or ERROR, the module is bad. Drag a memory module from the computer to the correct slot on the memory tester. Drag the Memory Tester from the Shelf to the Workspace. Test the memory modules in the computer as follows: Above the computer, select Motherboard to switch to the motherboard view of the computer.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |